1
Bug Reports / Re: Decimate Mesh - Selection Only - Not working
« on: June 05, 2021, 08:44:49 AM »
I believe it was 6.6 ish.
Just realised there is an update.
Just realised there is an update.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Bug Reports / Decimate Mesh - Selection Only - Not working
« on: June 04, 2021, 04:31:12 AM »
Wat's up crew!!! 
to reproduce;
select a section of your model
run the decimate mesh command with selection only
result: entire mesh is decimated
expected: only selection to be decimated
Peace all!!!
to reproduce;
select a section of your model
run the decimate mesh command with selection only
result: entire mesh is decimated
expected: only selection to be decimated
Peace all!!!
Pages: [1]
