1
Bug Reports / Re: Mesh generating stops at 35%
« on: November 18, 2022, 05:42:16 PM »
Tried it on SSD with 1.8.4 and it still not works :/
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Bug Reports / Re: Mesh generating stops at 35%
« on: November 18, 2022, 11:12:56 AM »
Dear Alexey!
Unfortunately the problem started on the SSD drive, with a different project
Updated to the latest version since, on HDD the problem persist, but I will try with 1.8.4 on SSD.
Best regards,
Tamás
Unfortunately the problem started on the SSD drive, with a different project
Updated to the latest version since, on HDD the problem persist, but I will try with 1.8.4 on SSD.
Best regards,
Tamás
3
Bug Reports / Mesh generating stops at 35%
« on: November 07, 2022, 05:17:49 PM »
Dear Community!
I stumbled across a problem recently, and I can't figure out what causes it. Mesh generation (arbitary) stucks at 35% and no matter what I try can't move forward.
Tried different datasets, projects, folders, re-install, nothing helps. Also did not revrite the folder name, there is enogh disk space, did everything perfectly the same like I did in the recent years.
Also can't stop the generating, I can only exit if I shut down the program.
I would highly appreciate if somebody could help, casuse right now I can't generate meshes.
The log can be downloaded from here: https://we.tl/t-Jc0BdkmyR2
(The last lines for some reason are in Hungarian, it says: Warning: Can't open file: The program gave out a command, but the lentgh of the command is not suitable)
Thanks in advance for the help!
Cheers:
Tamás
I stumbled across a problem recently, and I can't figure out what causes it. Mesh generation (arbitary) stucks at 35% and no matter what I try can't move forward.
Tried different datasets, projects, folders, re-install, nothing helps. Also did not revrite the folder name, there is enogh disk space, did everything perfectly the same like I did in the recent years.
Also can't stop the generating, I can only exit if I shut down the program.
I would highly appreciate if somebody could help, casuse right now I can't generate meshes.
The log can be downloaded from here: https://we.tl/t-Jc0BdkmyR2
(The last lines for some reason are in Hungarian, it says: Warning: Can't open file: The program gave out a command, but the lentgh of the command is not suitable)
Thanks in advance for the help!
Cheers:
Tamás
Pages: [1]
