Show Posts
1
Bug Reports / Re: CUDA Crash during dense point cloud processing
« on: October 06, 2023, 01:41:44 PM »
this happens to me all the time, i am on on a 4090t1 and i910k with 128gb ram on Windows 10 - when i finish processing one asset (in full so align / make mesh / texture / smooth / export model) and then start a new project, after the initial alignment i get the same cuda error when i try to build the mesh
Note that i am processing a lot of assets back to back so it a pain to reboot every time (that fixed it). After a lot of headache i found a simple solution - in the Windows Device Manager, simply go to Display Adapters and Disable (wait a few seconds) then re-Enable your Graphics card.
The screen gets messed up (windows move around) but i am able to keep working without a reboot and its fast....
Seems that metashape is not cleaning up the CUDA que properly after finishing its jobs ? There is a way to reset the CUDA systems at the command line but i cant get it to work that way.
Note that i am processing a lot of assets back to back so it a pain to reboot every time (that fixed it). After a lot of headache i found a simple solution - in the Windows Device Manager, simply go to Display Adapters and Disable (wait a few seconds) then re-Enable your Graphics card.
The screen gets messed up (windows move around) but i am able to keep working without a reboot and its fast....
Seems that metashape is not cleaning up the CUDA que properly after finishing its jobs ? There is a way to reset the CUDA systems at the command line but i cant get it to work that way.
