Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics -

Pages: [1]
General / Fiducials and DEM strange behavor
« on: September 26, 2019, 12:15:54 PM »
Hellow, I'm trying work with old photograms, when I put all fiducials ( 8 ), I obtain a good errors  but when I generate dense cloud and depth maps, the depth maps are cut.
I tried to only put 4 fiducials and the errors are worse >:( but depth maps aren't cut  :).
some one knows why this behavor, I doing somethig bad or is a metashape bug?
I'm working with version 1.5.5 bulid 9097 (64bit)

Bug Reports / APS 1.0.3 don?t close holes
« on: April 02, 2014, 01:39:03 PM »
Hello, I have a problem since I installed the 1.0.3 version, when I build a mesh setting height field, the resulting surface has holes and I can't close it even with the Tool "Close Holes", this tool freeze the computer  :o, my configuration is radeon R9 290, RAM 64Gb, I7 and Windows7.
I tested this with several projects with the same result.
Where I could download previous versions, to continue working.


General / About accuracies
« on: February 18, 2014, 01:31:25 PM »
I've doubts about errors in PS:
In Ground control setting for "marker accuracy", I don't understand exactly its meaning I think is the RMS (x,y,z) of GPS measures.
Are the errors on Ground Control Pane the accumulate error on GPS measures and photogrametric process?
I think understand errors for profesional use is essential.
Thanks Agisoft team.

General / Problem with DEM in shadows
« on: January 31, 2014, 12:50:43 PM »
Hi, I?ve a problem with shadows when I generate dense point cloud, shadows are below the surface (10cm aprox), the surface is a basketball court and the GCP were taken with very accurate GPS (double frequency), with a higth overlap 80%-80% and low noise sensor.
Also the surface (that is smooth) seems too noisy. If I set agressive map filtering, this improve but not enough.
I?m going to try mask shadows, but is tedius. Someone knows why this happen? I hadn?t this problem with others cases on irregular surfaces.

General / Help with new tool classify points
« on: January 23, 2014, 06:56:38 PM »
Hello I'm testing the new tool in 1.0.0 release to classify ground points. Seems great but the trees base (at 1.5m approx) are classified like ground, seem like stumps. I tried tuning the tool parameters without succes.
Somebody know how solve this problem, thanks.

Pages: [1]