Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - 3DFranz

Pages: [1]
General / 3D Print of Landscape- / City-Model
« on: August 17, 2018, 03:10:42 PM »
I would need some Advice how to PrePare an Agisoft OBJ File for 3D Printing.
It is an Landscape Model with Buildings, as example shown in the Screenshot.

The Model should be Printed in about 50 x 50 x 10 cm.
Any suggestions about the wall-thickness, or the Software to use for preparing the model for Printing?

Camera Calibration / Lens Preferences Pattern Step & Frame border
« on: June 17, 2014, 01:39:07 PM »
Under Agisoft Lens, --> Tools --> Preferences
There is a Pattern step & Frame border.
What do these values mean?

thx for your help

Bug Reports / 3D PDF Model Export
« on: August 12, 2013, 12:09:38 PM »
In Version 0.9.0 it was possible to export a 3d PDF in a geographic or projected Coordinate System system. This option is disabled in version 0.9.1 (only export in local coordinate system).
Why is this function in 0.9.1 disabled? (will this function be enabled again in the next update?)
Thx for help.

Pages: [1]