Topics

1

General / Draw 3D Polylines

« on: April 06, 2016, 05:36:50 AM »

Hi everyone!

Is there a way to draw 3D polylines, and export them to a dxf?

IE: Instead of exporting the wireframe mesh, I want to trace the mesh and export what I traced.

Pix4Dmapper gives the ability to draw 3D Polylines, and export them to to a dxf; so I was wondering if Agisoft Pro does too.

Thanks!

2

General / Model built on incorrect plane

« on: January 26, 2015, 02:25:48 AM »

I'm having an issue with the model being constructed on the incorrect plane in Agisoft Photoscan. I'm not sure if this can be addressed by just using the Pro version. Every time I export the model, it's always on a 45 degree angle through the zero Z axis plane.  This is hard to explain, so I attached two images that should clarify what I'm talking about.... Is there a way to 'mate' the bottom of the model flush to the zero Z axis plane??

THANKS!

3

General / GoPro not working with v1.1.0 update

« on: January 04, 2015, 08:17:06 PM »

I recently upgraded PhotoScan to the new version 1.1.0, and now i can't generate a point cloud using a chunk from my GoPro.  I know GoPro's are not the best for photogrammetry, but if you use the GoPro in the case, it flattens the lens and i was always able to generate a model this way with the older software version.

When i tried the new v1.1.0 for the first time with new images, i was unable to generate a point cloud, even though I had 117 photos with an an average of 60,000 points per image when aligning. I thought i had an issue with my images. So I used a chunk from a previous project (used a GoPro) that i processed fine using the older software. I was unable to generate a point cloud with this chunk too. Something's not right here. Either there is a new setting that I am missing, or v1.1.0 doesn't support GoPro's.  Can I revert back to the older version somehow, please???

Thanks for your time!!