1
General / Force agisoft to use photos?
« on: September 04, 2016, 02:05:35 AM »
I noticed there are quite a few photos that our UAV took that were ignored it seems.
I've attached a picture of an area that shows quite a few "dots" where there was a photo taken, but the image was not used during generation of the tie points and subsequent processes.
Is there any way to figure out why this is the case? Can I force agisoft to use the images?
Thanks.
I've attached a picture of an area that shows quite a few "dots" where there was a photo taken, but the image was not used during generation of the tie points and subsequent processes.
Is there any way to figure out why this is the case? Can I force agisoft to use the images?
Thanks.