1
General / Attempting to merge manually aligned chunks
« on: December 16, 2023, 07:11:05 PM »
I’m not sure if this is a bug or if I’m trying to use metashape incorrectly
I have a model of a medieval effigy of a lady. It is broken into two parts, one stacked on top of the other and placed in a wall recess in a church. My aim is to reunite the head in the correct position.
I have duplicated my original model into two new chunks, then disabled the original model.
In each of the two new chunks I have carefully trimmed each model to the areas that I need.
Select “Show Aligned Chunks” on toolbar, then repositioned and reorientated the chunks using the transformation tools “Move object” and “Rotate Object” – “Scale Object” doesn’t need to be changed since both chunks are from the same source.
When I merge the chunks then deselect “Show Aligned Chunks” - I’m left with one chunk with its region on a different alignment and no merging having occurred.
I’m loosely following these instructions using a model rather than point cloud. https://agisoft.freshdesk.com/support/solutions/articles/31000157701-manual-chunk-alignment-standard-edition-
Metashape 2.0.4 build 17434 (standard)
i7-13700k, 64GB Ram, RTX 3080 12GB (driver version 545.84)
I have a model of a medieval effigy of a lady. It is broken into two parts, one stacked on top of the other and placed in a wall recess in a church. My aim is to reunite the head in the correct position.
I have duplicated my original model into two new chunks, then disabled the original model.
In each of the two new chunks I have carefully trimmed each model to the areas that I need.
Select “Show Aligned Chunks” on toolbar, then repositioned and reorientated the chunks using the transformation tools “Move object” and “Rotate Object” – “Scale Object” doesn’t need to be changed since both chunks are from the same source.
When I merge the chunks then deselect “Show Aligned Chunks” - I’m left with one chunk with its region on a different alignment and no merging having occurred.
I’m loosely following these instructions using a model rather than point cloud. https://agisoft.freshdesk.com/support/solutions/articles/31000157701-manual-chunk-alignment-standard-edition-
Metashape 2.0.4 build 17434 (standard)
i7-13700k, 64GB Ram, RTX 3080 12GB (driver version 545.84)