Topics

1

General / Error when generating mesh

« on: May 11, 2016, 09:13:38 AM »

I get this error when generating a mesh

2016-05-11 06:41:06 Error: bad allocation
2016-05-11 06:41:06 Finished processing in 635.662 sec (exit code 1)
2016-05-11 06:41:06 Error: Operation not applicable

Whats wrong?

2

General / View Error

« on: May 10, 2016, 01:58:46 PM »

Hello fellow geeks end experts,

I have just finished a drone flight with an altitude of 11 m.
I have finished placing the markers in Agisoft Photoscan and have just optimized the cameras. When I look at the errors, I get higher error values than I am use to (see attached). Is this a problem? I assumed the errors to be lower when I fly so low.
The GCP have been measured with high precision by a surveyer.

Hope that someone can help me :-D

3

General / Cant align photos

« on: February 14, 2016, 02:27:44 PM »

Hi,

I have done a flight in an area with a lot of forrest. The problem is that Aigisoft Photoscan cant align the photos in the areas with many trees (see the attached file).
What do I do?
Can I do some manual aligning pointing put control points?

4

General / Place Markers

« on: February 09, 2016, 02:00:18 PM »

I am placing markers at my ground control point. I have filtered my photos by marker. The problem is as follows:
In some of the pictures the ground controls points is covered up by trees or constructions. How do I disable or ignore the GCP  in the picture but without ignoring the actual picture. I would still like to use the picture in the photogrammetric calculation, just with out including the GCP.

BR

Jacob

5

Bug Reports / Errors and precision

« on: January 03, 2016, 05:56:36 PM »

In my error repport i suddenly have some high value errors in my GCP 1115-1121.  How big a problem is this regarding the overall precision of the project?

BR

Jacob

6

General / Errors and precision

« on: January 03, 2016, 05:54:55 PM »

In my error repport i suddenly have some high value errors in my GCP 1115-1121.  How big a problem is this regarding the overall precision of the project?

BR

Jacob

7

General / Geotagging

« on: December 22, 2015, 05:28:07 PM »

I have deleted the pictures taken when taking off and landing before I started geotagging from my logfiles.
Now I have a big problem aligning my pictures with the logfile. I know I can manually drag the time slider, but Im not sure where to drag it to. My camera and Aibots clock was not perfectly syncronized either. Any tricks to align the logfile with my pictures?

BR

Jacob