Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - urancle

Pages: [1]
1
General / Drawing tools dont work in ortho mode
« on: November 20, 2016, 07:50:13 PM »
Hi all!

I try to edit seamlines in an orthomosaic, but i cant draw anything. While drawing, on double click or click on the first point of a polygon to close it, it just vanishes and i can't assign the images. None of the drawing tools works. It works in model mode drawing in the mesh, but not in ortho mode in the mosaic.

What am I missing? Mosaic source is an imported DEM, and not a mesh if this does matter. But I can not find any possible exclusions for the drawing tools in the manual.

Thanks for any hints!

Regards,

Urs

Pages: [1]