Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Yes21

Pages: [1]
Bug Reports / 1.4.1 Problem with Sequoia pictures
« on: April 18, 2018, 12:27:49 AM »
I'm new to PhotoScan and this forum.
I've chosen to try it because it is the only photogrammetry software that runs under Linux.
I use a Sequoia multispectral camera for forest mapping and diagnostics.

A few months ago, I did quick tests with 1.3.4 (demo version). I were able to load the 4 TIFF bands (multispectral mode) in one chunk, and the RGB in another chunk. Then I could align pictures, build mesh and texture, for each chunk separately. It was a good beginning, but I didn't have time to go further.

Now I try to test the complete workflow with the latest version (1.4.1) and the trial licence.
I can load the same pictures the same way as with 1.3.4, but can't align them for both chunk. After a few seconds, the process stops with error message "Null photo" !!

Do you know what happens ?
Could you help me ?

Best regards.

Pages: [1]