Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - DCSK

Pages: [1]
1
We keep on getting this error (Kernel failed: unspecified launch failure (719) at line 269)
After aligning photos for about 20 minutes.
We have tried a fresh install, updating drivers using older drivers turning off and on the "use CPU" In the GPU preferences.
The project has about 2000 photos, but can't get past the detecting points stage.
We have never had this problem before. Although we swapped in  a new GPU that was working fine in another work station and I believe this is the biggest job it has ran since it's been installed (it ran bigger jobs on a different workstation with no problems) 
Using GPU Z it shows that the GPU [RTX 2080 Super] load is only 9% and the CPU [Ryzen 9 3950X] is under 10% load as well and the ram is at 6gb out of 64

I have attached the log as well

Any help would be greatly appreciated
 


 

2
Bug Reports / When Aligning photos PC freezes
« on: March 24, 2023, 01:38:08 PM »
When aligning photos on some jobs the whole pc would just freeze, it doesn't blue screen just freezes on the window it was open on.
The ram and gpu won't under heavy load only the CPU was at 100%
temps were fine

The job had 3,500 photos

The specs of the PC are as follows

CPU: Ryzen 7 3700x
RAM :64 GB
GPU: RTX 2080 Super



3
General / BUILDING A WORKSTATION PC - gtx super 2080 or TWO gtx 1070ti
« on: September 12, 2019, 12:19:12 PM »
I'm building a new workstation and was wondering what would work better a gtx super 2080 or two gtx 1070ti
I'm not decided on the CPU but was going for a Threadripper 2990wx ( the 32 core one) and 128gb RAM
an average project has 8000-1500 photos. And Building the dense cloud is always the longest step so I was thinking the more cores the better. 
I'd appreciated and advice. 

Pages: [1]