Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - metashape.td

Pages: [1]
1
General / [solved] Volume calculation "fails" because volume is to small
« on: August 02, 2021, 09:51:25 PM »
We are trying to measure the volume of peat moss capitula using a low cost scanner and Metashape. We are quite satisfied up to know, but some of the measurements fail because the volume of the capitula is to small. The volume is simply 0.0 if it is below 1e-8 or so.

Is it prossible to set a higher precision for volumes smaller than e-8?

Pages: [1]