Topics

1

General / Question relative to Ukrainian crisis

« on: March 03, 2022, 09:43:29 AM »

Dear Metashape team,

considering the crisis which is taking place in Ukraine, some national recommendation are popping-up to avoid Russian software (not direct mentio about Metashape so far). I never thought I will be asking such questions on a software support forum one day...   

- Assuming that economical sanctions and national cybersecurity agency decisions will still give us the choice to use Metashape, are you able to take measures to demonstrate that it will not be used as a supply chain attack vector ?

- Are you aware of what is taking place in Ukraine (i.e. Russia army upon Putin's decision is attacking a sovereign country and killing civilians) ? TV here shows some protestations are happening in St-Petersburg against this war. Are you in a position to tell us what side you are sitting on ?

Best regards,

Mathieu Peyréga

2

Feature Requests / Disable some picture for automatic seamlines only

« on: October 07, 2021, 11:43:52 AM »

Hello,

we have a aerial workflow use case where we'd like to disable some pictures (usually a full flightline or picture set in case of multiple pass over same area) for the automatic seamlines / orthomosaic build step, but still make them available for manual "best image / seamline edition" choice later in the process.

Unless we missed something, I believe that software in current state does not allow this. If we disable pictures, they are disables for all next steps. Or is there a way to achieve this ?

We believe that having a "disable for auto-seamlines only" feature would be nice (and probably not too hard to implement).

Best regards,

Mathieu

3

General / Agisoft freshdesk ticket system

« on: December 09, 2020, 06:36:21 PM »

Hello,

I submitted 2 tickets to https://agisoft.freshdesk.com/ about 1 month ago and got no feedback since that other than the automatic ack). Is this support desk still active ?

Best regards