Topics

1

Feature Requests / Request for DJI Inspire 3 Syntax for Mission Plan

« on: September 12, 2025, 11:52:17 AM »

Good Morning,

Can you please support the DJI Inspire 3 for mission planning? The available aircraft (E.g. the M300, M30, etc) missions can't be used with Pilot 2 in the Inspire 3 as it expects a different syntax.

The Inspire 3 can be far more easily transported than the M300, as the batteries are below the required airline limits and has a large sensor which is great for certain jobs.

Thank you for your consideration.

2

Bug Reports / After "Build Tiled Model" Texture resolution is substantially degraded.

« on: April 02, 2024, 08:46:43 AM »

Good Morning.

I am having an issue where once i tile an OBJ model the texture is significantly worse than it was prior to tiling. The screenshot shows the quality of the model as displayed by Agisoft and again for the same model after tiling (i have made sure that the highest quality LOD is visible). the model is textured to 1mm and i am tiling to 1mm.

If i cut the OBJ down in size to a smaller area it maintains the quality (It makes 5 levels instead of 6) but the OBJ and the Tiled model look the same once fully zoomed in. The OBJ i am trying to process is only 6.88 Gb with 1.36Gb of textures, textures are UDIM and jpg 24bit and the mesh has 65million triangles. It takes approximately 1 hour and 20 min to tile.

I have run the same project with GPU enabled (RTX 4090) and only CPU options and have achieved the same result for both.

I have attached my settings as a screenshot.

I have achieved the same result on "Agisoft Metashape 2.1.1" and "Agisoft Metashape 2.1.0".

I am running intel 13900k, RTX 4090 and 192GB ram.