Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - wes

Pages: [1]
1
General / Problems building geometry
« on: May 15, 2012, 11:32:32 PM »
First off, thanks for making this software.  I had been using bundler and photoscan solves much better and makes my life easier, so thanks again.  I usually am modelling outdoor roadway scenes which works very well when done with aerial photos.  Recently I did a scene where the photos are all ground level (eye height) as I walked down the lane of the road.  So the photos are mostly in line facing the same direction.  I am using photoscan 0.8.5 standard and the photos aligned well and the point cloud looks good.  I have compared the point cloud to survey points I took at the scene and they agree nicely.
However, when I try to build geometry, it only builds sparse geometry for objects that are mostly vertical in the scene.  None of the roadway is modeled.  I've tried every combination of generic/height field smooth/sharp point cloud/low/med/high and nothing seems to make a difference.
I'm wondering if the low angle between the photos and the surface is preventing reconstruction and if there is any setting to adjust this.

Thanks,

Wes

Pages: [1]