1
Bug Reports / Re: cancelling orthophoto creation waits until color correction finished
« on: March 12, 2015, 02:14:40 PM »
Same for me here, I am hitting the "cancel" button when system is doing color corrections, and it just would no stop.
It says 100% done, but it would not stop. I have 400 pics of 2 mega pixels each, mesh was done quickly.
Clicking on Pause makes the button greyed out for a few seconds than comes back active and nothing happen.
So I am getting stocked on the final step and cannot get end result... Too bad.
It says 100% done, but it would not stop. I have 400 pics of 2 mega pixels each, mesh was done quickly.
Clicking on Pause makes the button greyed out for a few seconds than comes back active and nothing happen.
So I am getting stocked on the final step and cannot get end result... Too bad.