Messages

1

Bug Reports / Re: Photoscan Version 1.0.4.1847 Texture Build Crash

« on: July 15, 2014, 09:50:43 PM »

Alexey,

It appears that our system simply doesn't have enough memory to handle a large amount of photos at their current size/resolution. I've been analyzing smaller sub-sets of photos and haven't had any issues. Thanks for your time.

2

Bug Reports / Re: Photoscan Version 1.0.4.1847 Texture Build Crash

« on: July 15, 2014, 09:17:46 PM »

Working with a chunk containing:
36 cameras
Each photo is roughly 17000 x 17000 (some are slightly smaller)
Dense cloud has 45933704 points
3D model: 2996307 faces

Texturing Parameters:
Mapping mode: Orthophoto
Blending Mode: Mosaic (default)
Texture size/count: 4096
Color Correction Enabled

Working on Fedora 20
47.2 GiB memory
Intel Xeon CPU E5520 2.27 GHz x 16 processor
64-Bit
GeoForce GTX 780 graphics
Gnome Version 3.10.2
478.8 GB available on disk

Work Log:

Patameterizing texture atlas...
Calculating color correction...
collecting control points... collected 7951518 points in 7.56179 sec
analyzing 36 images...

At this point the program closes completely. We're looking into the possibility over here of some kind of bug on our computers or operating systems.

Thanks!

3

Bug Reports / Photoscan Version 1.0.4.1847 Texture Build Crash

« on: July 15, 2014, 08:19:04 PM »

I am working with a large amount of historical aerial photographs with the intention of creating orthophotos. I am unsure if this version of Photoscan is the most recent update or not, but the program seems to think that it is (under check for updates it says that no update is required).
When building textures for the aligned photos the program runs for approximately ten minutes each time before closing Photoscan completely.

Thoughts? As always, thank you for your time/advice! 

4

General / Re: Chunks from different .psz files

« on: June 18, 2014, 07:00:55 PM »

Frank,

Thanks for the tip, will try that this afternoon!

Patrick

5

General / Chunks from different .psz files

« on: June 18, 2014, 05:42:02 PM »

Hey,

I'm relatively new to Photoscan and was curious if anyone had some advice on if there was a good way to manage several chunks from different working projects. I am compiling orthophotos of a very large area in Puerto Rico and have been splitting them up by different municipios (essentially counties). The end goal however is to have one orthophoto of the entire area. Should I be aligning ALL of the photos at one time, in one project, or is there an easy way to move photos and their respective markers from other projects into one big project?

Thanks,

P