1
General / Re: Agisoft Metashape 1.7.0 pre-release
« on: December 16, 2020, 02:06:48 PM »
Hi,
I wanted to test that new laser scans meshing function, but it does not work for me. I've sucesfully imported and aligned the scans, but when I try to make a mesh from them, I just get error "Not enough cameras". The scene is 54 laser scans made with Leica RTC360, scans were registered in Cyclone Register 360 and exported as E57. There are no photos, just the scans (which is probably the main problem). Am I doing something wrong, or is in current version not possible to mesh laser scans alone, without any photos?
Thanks.
I wanted to test that new laser scans meshing function, but it does not work for me. I've sucesfully imported and aligned the scans, but when I try to make a mesh from them, I just get error "Not enough cameras". The scene is 54 laser scans made with Leica RTC360, scans were registered in Cyclone Register 360 and exported as E57. There are no photos, just the scans (which is probably the main problem). Am I doing something wrong, or is in current version not possible to mesh laser scans alone, without any photos?
Thanks.