Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nazg

Pages: [1]
1
Bug Reports / Re: Bug with nvidia driver 364.51 ?
« on: March 25, 2016, 10:10:08 AM »
Ok, I had to switch my gpu pci-e slot because I needed to install another extension card.
And now the OpenCL device is appearing.

I have no idea what could have gone wrong.

2
Bug Reports / Re: Bug with nvidia driver 364.51 ?
« on: March 20, 2016, 11:44:27 AM »
Geforce GTX 680

3
Bug Reports / Bug with nvidia driver 364.51 ?
« on: March 19, 2016, 07:50:13 PM »
Hello,

I updated my graphic card drivers with the last nvidia whql release (after all the trouble with the two past whql/beta releases, anyway).

It seems that photoscan 1.2.3 is not recognizing my gpu opencl capabilities anymore, while everything seems to be in order through GPU Caps "OpenCL 1.2 CUDA 8.0.0" "364.51".

Am I the only one having trouble ?

Best,

4
General / Re: CPU and GPU benchmarks
« on: November 21, 2015, 08:26:49 PM »
Dear Community ;)

I have started to crate a table for recording the results of this thread. Maybe you could create there a good overview for all Agisoft Users. (maybe you could also write down your experience in other wiki topics/pages)

http://wiki.agisoft.com/wiki/Hardware

It would be even better if you said what is the meaning of the numbers, because it's not obvious that they are million samples/sec. To be honest it took me sometime to figure it out.
I will try to launch a test with our new dual k5200 setup to add a new input in the table.

Best,

5
Python and Java API / Re: Script for exporting orthophotos using markers
« on: August 03, 2015, 10:08:08 AM »
I would also be interested in such a script !

6
General / Most effective use of network computing ?
« on: March 22, 2015, 02:11:05 AM »
Hi,

I set up a small network computing system, and I was wondering what was the most effective way of using it at its full potential ?

I read the manual, and launched some test, but I am still not quite sure how it works.
Say I have big building interior for which I have around 1000 photo allocated to four arbitrary spatial entities. Those arbitrary spaces are church spaces like : entrance, nave, choir, etc...

The right thing to do would be to make a chunk for every spatial entity, and work them independently throug alignment, dense cloud and meshing, until I bring them back together at the end ?

In fact I quite don't understand how each node is summoned. I thought  (naively perhaps) that I could launch an heavy task related to a big single chunk, and each node would take a part of the computing. Or maybe my setup is wrongly configured, because every time I launch a task, only one node is working while all ther others are desperately idling as "ready".

To be honest, it would be really helpful to add some processing tips into the manual, or some kind of showcase, like the doll or statue.

Best,

Pages: [1]