Messages

1

General / Re: Texture mapping problems...No memory message

« on: January 09, 2016, 09:41:22 PM »

Hello

Ok, so from the attached photo it is seen tha faces and the options i put for the texture, in this case for the mesh i had a medium quality point cloud and the options for the mesh were (Arbitrary, High for polygons, Diabled Interpolation), but only on this chunk the options are like this and the texturing didnt work.

Other chunks are with high quality point clouds, the mesh options are (Arbitrary, 0 polygons, because with the other options it didnt work, Disabled Interpolation) and there as well the texturing didnt start. Example: one chunk that has 212 cameras, has a mesh with 234 568 685 faces.

2

General / Re: Texture mapping problems...No memory message

« on: January 08, 2016, 12:19:33 AM »

Hi,

Yes, I have 64-bit Photoscan version. I re-run the texturing process and now from 3 hours is on the stage Parameterizing texture atlas (70%) with not estimated finishing time, the use of the RAM is not full, only 4GB our of 12.  Then it gave again out of memory message, like previous times... 

3

General / Texture mapping problems...No memory message

« on: January 07, 2016, 01:04:08 PM »

Hi everyone,

I am having  problem, when trying to do the texture of a chunk with 60 cameras (a room). I put first  Generic, Mosaics, 4096x1 and also tried with Generic, Average 4096x1, but a Not enough memory message appears. I assume it is from the RAM, but do you have any suggestions how i can do the texture? The RAM of the PC i use is 16 GB. The thing is that I need to do the texture also on a chunk with 200 and 400 pics...
My photos are very high resolution (probably this is problematic) 5760x3840 pixels and i am not sure what parameters to put in the Texture size/count part...

Thanks in advance!

4

General / Re: orthomosaic coloration problems

« on: January 05, 2016, 03:08:39 PM »

Hi everyone,

I am having similar problem, when trying to do the texture of a chunk with 60 cameras (a room). I put first  Generic, Mosaics, 4096x1 and also tried with Generic, Average 4096x1, but a Not enough memory message appears. I assume it is from the RAM, but do you have any suggestions how i can do the texture?
My photos are very high resolution (probably this is problematic) 5760x3840 pixels and i am not sure what parameters to put in the Texture size/count part...

Thanks in advance!

5

General / Importing separately aligned chunks into one plz document

« on: December 24, 2015, 02:38:11 PM »

Hello,

I am currently working on a project which is quite big and i had to separate it in chunks and align photos and chunks in different PC, so to be faster. I am struggling to understand how I can import now the aligned chunks into one plz file, which I will use for the dense point cloud and meshing phase? I did the alignment according to points and it is OK, but now I have to basically substitute the non-aligned chunks with the aligned ones from the different plz files.

Respectively, I will have to import also the different meshes at the end so to have one file with all the chunks aligned and meshed.

If anyone has experienced the same and has some advice it would be very useful. Thank you!