Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - urancle

Pages: [1]
1
Hi Alexey

You find the log in the attachments. I tried all interpolation modes as well as various ex- and import formats.

Thank you!
Regards
Urs

2
Hi & thanks for your answer Alexey

I've aligned 30 aerial images with 100MP resolution, measured GCPs, optimized the cameras and built a DenseCloud on default High settings. I've exported a part of it (defined by the region) and imported this partial cloud with 4'073'236 points into a duplicated chunk.
When i build the Mesh it estimates approx. 800'000 faces on High but i end up with only 3'324 faces. I tried a custom face count but no matter how much i specify i end up with the same 3'324 faces.
Edit: i tried resetting the region to the full extend of the aligned images as well as limiting the region even a little more on the area which is covered by the imported dense cloud.

I have added screenshots showing the imported dense cloud and the processed but "failed" mesh.

Regards
Urs

3
Hi fellows

I'm facing the same problem... Did you found a solution?

Thanks & cheers

4
Hi Steve

You can achieve this with DaVinci Resolve. It is a free video editing software from Blackmagic Design (they produce cinema cameras). Besides the function you need it is maybe the best software for color grading.

5
General / Re: Drawing tools dont work in ortho mode
« on: November 22, 2016, 12:22:53 AM »
Thanks for your answer Alexey!

As far as i remembered i did not have any shapes in it. I just processed another tile, checked again, and it works! :) pretty cool, i already feared this does not work if the mosaic source isn't processed out of the images.

Thanks again, i'm busy now ^^

6
General / Drawing tools dont work in ortho mode
« on: November 20, 2016, 07:50:13 PM »
Hi all!

I try to edit seamlines in an orthomosaic, but i cant draw anything. While drawing, on double click or click on the first point of a polygon to close it, it just vanishes and i can't assign the images. None of the drawing tools works. It works in model mode drawing in the mesh, but not in ortho mode in the mosaic.

What am I missing? Mosaic source is an imported DEM, and not a mesh if this does matter. But I can not find any possible exclusions for the drawing tools in the manual.

Thanks for any hints!

Regards,

Urs

Pages: [1]