Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Eirik Strøm Pedersen

Pages: [1]
1
General / Re: Workflow to process the Photography of "PHANTOM 4 RTK"
« on: January 17, 2019, 01:25:40 PM »
Hello Steve,

The accuracy values for the coordinates should be properly read from XMP, providing that you have enabled "Load camera location accuracy from XMP meta data" in the Advanced preferences tab.

If it doesn't happen, please provide any example of the image that you are using (either via forum or via email to support@agisoft.com).

Does anyone know if the data in the Timestamp.mrk file are calibrated between the antenna position and center sensor camera? 

2
General / Re: Workflow to process the Photography of "PHANTOM 4 RTK"
« on: January 16, 2019, 04:19:35 PM »
Hey everyone.

As i understand it you recommend to turn of the Distortion Correction in the DJI Flight Software? And then do a manual calibration where you import the .mrk file into Metashape?

3
Bug Reports / Re: Converting coordinate system bug
« on: July 11, 2017, 02:50:03 PM »
I builded them after the conversion, and the Pointcloud was correct, but the orthofoto did not work like it should.

4
Bug Reports / Converting coordinate system bug
« on: July 11, 2017, 02:04:07 PM »
Experience a bug when converting from the project with the convert-tool. The coordinates that follows the images and the markers are converted correctly, but it seems like it does not change the coordinate system in the settings window. I just tried to export a orthofoto from photoscan after I've build it with the correct coordinatesystem (UTM 32) and exported it with UTM32 checked. I lunched the orthofoto in a other software, but the coordinate system was NTM8. Then I checked the settings window and found that the project system was indeed NTM8, but the markers and the pictures where indeed in UTM32. Shouldn't the entire project convert when Im using the convert tool?

I'm using the 1.3.2.4205 version with QUDA-support.

5
Feature Requests / ECW export
« on: May 24, 2017, 10:30:30 AM »
It would be very handy if you added ECW-export as an option in Photoscan. The filesize is much smaller than the regular image format and typical GIS softwares loves ECW compared to JPG/TIFF etc.....

6
I having problems with the new version of Photoscan. The program crash during the build dense cloud operation. Anyone experience some of the same issues? It seems to be related to CUDA or grapich drivers. My grapich drivers are up to date as they was updated last week by the service department in our company last week, so that cannot be the issue.

Right now I'm useing a modded version of Photoscan delivered by Agisoft that solves the issues with running GPU operations with Open CL. But this soulution are just temporary. Attached is the overview of my grapich cards.


Pages: [1]