Messages

1

General / Re: a sudden raise of 50 m in elevation after align photo

« on: May 07, 2017, 04:45:21 PM »

Dear all,

The issue was probably the overlapping done was too low, along track 80%, accorss track 60% as Jan anticipated. I have managed to solve the issue by align and optimize them with GCPs in separate chunks and then execute merge chunks.

Thanks a lot.

Cheers,
Desmond Tan

2

General / Re: a sudden raise of 50 m in elevation after align photo

« on: May 04, 2017, 11:32:26 AM »

Hi Jan,

Thanks a lot for the suggestions. Yes all of the photos were aligned generally, the last attempt was checking only generic preselection with key points 40000 and tie points 10000 but resulted the same. Now i am trying with checking reference preselection only, however, it is taking longer time to align photos.

Thanks,
Desmond Tan

3

General / a sudden raise of 50 m in elevation after align photo

« on: May 04, 2017, 04:34:18 AM »

Dear Sir,

After doing align photo, there is a sudden raise of 50 m in elevation. The purpose is to generate DEM and Orthophoto from aerial photo. The photos were taken at multiple ground altitude depending on the site elevation, in terms of altitude, there seems to be two batches, i.e. at altitude 200 m and at altitude 300 m. When doing align photo, generic and reference preselection were ticked. The points from altitude 300 m seems to be separated from the points from 200 m altitude with a raise of approximately 50 m in elevation. Is there any way to solve this issue? Please see attachment for illustration.

Thank you.

Best regards,
Desmond Tan