Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - ejr32123

Pages: [1]
General / Re: remove points by confidence
« on: April 26, 2021, 04:23:09 AM »
hmm, I actually found the solution, its because filter points by confidence was doing the opposite of what I thought it was. I needed to set my min to 0 and max to 2, I thought it was leaving the good points, but turns out it was displaying the bad points, so I can just select them hit delete then reset filter.

General / remove points by confidence
« on: April 26, 2021, 01:24:50 AM »

I am just trying to delete low confidence points, but for some reason it is really difficult. So I select dense cloud, then filter by confidence, then I set threshold to 2-255. Then I did compact dense point cloud thinking it would delete the removed points but that does not work.  Then I tried filtering by confidence, selecting all the points, then inverting selection, then reset filter, but no points are selected. Then I figured I could select the points I dont want. So instead of setting threshold to 2-255, I set it from 0 -2 hoping to select all the low quality points, but that does not work either. so how am I supposed to delete the low confidence points? I am using the standard edition.


General / Re: Camera alignment
« on: February 07, 2018, 06:07:43 PM »
I am using a 100mm macro lens. The objects we are shooting are very small.

General / Camera alignment
« on: February 07, 2018, 05:36:09 PM »

I have a question about camera alignment. I noticed that with some of my objects, some cameras will not align correctly no matter what settings I use. However, if I select all the faulty cameras and click reset alignment, then choose to align them again, the cameras all align perfectly. If the cameras can be aligned correctly, why doesn't it work the first time you align them?


Bug Reports / Re: Texture Generation problem
« on: January 26, 2018, 05:06:01 PM »
Thanks : )

Bug Reports / Re: Texture Generation problem
« on: January 25, 2018, 11:25:01 PM »
Yep! here they are...

Bug Reports / Texture Generation problem
« on: January 25, 2018, 10:34:06 PM »

I had been using an old version of photoscan, v 1.3.3. so I updated to v 1.4.0. I noticed that when I generated a texture, the texture was triangulated and blurry. I couldn't figure out how to fix it, so I moved on to my next model. However, it did the same thing. So I installed 1.3.3 again and the build texture started working again. Any one else had similar problems?



Pages: [1]