Messages

1

General / Re: About a few issues on mesh

« on: May 21, 2018, 11:07:32 PM »

Attached file

2

General / Re: About a few issues on mesh

« on: May 21, 2018, 11:05:58 PM »

Hello Alexey,

Thanks for reply.
I used the following settings:

Key Point Limit = 40,000
Tie Point Limit = 10,000

I launched a new workflow with these settings and following what you said.
That's to say :

Apply masks to key points.
Without any camera model fitting.

I got this result (screenshot).
It's good but it could be better. I mean it lacks a little bit of resolution.
How can we improve it ?

Another problem is as I export the mesh to Maya, it looks smoothed. I do not understand why.

Thanks for your help.

3

General / About a few issues on mesh

« on: May 21, 2018, 03:21:17 PM »

Hi,

I scanned a bust with a turntable and the result is pretty good.
I have some remaining issues I would like to understand.
I've got 271 photos and each photo gets its own mask.
I applied masks to Tie points.

1/ The chest is like a plane without any detail.
I checked with the green arrow this region that is rendered as you can see on the attached file, that's to say a little bit weird.

2/ There is absolutely nothing behind the head and I don't understand these small chunks of mesh (red arrows).

Thank you for your explanations !

4

General / Re: New alignment parameter for background suppression

« on: May 21, 2018, 11:10:33 AM »

Hi thanks for reply.

I have 271 photos.
I made and loaded the 271 masks.
And now I can change the field "Apply masks to".

Thanks again !

5

General / Re: New alignment parameter for background suppression

« on: May 20, 2018, 05:53:18 PM »

Hi,

In Photoscan 1.4.1 Pro, I have no access to this feature as shown on the screenshot.
How do I proceed ?

Thanks.