Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Pempel

Pages: [1]
1
General / Volume not measured in Ortho view
« on: November 19, 2018, 11:19:51 AM »
Hi,

I want so use Agisoft for Volume measurement. I use the Ortho view but after drawing a polyline in the measure shape 'Volume' is not enabled. I don't understand why the volume can't be calculated.
I also have an general question: is it possible to calculate the difference in volume of two different point clouds? (I want to calculate the volume of garbage in a waste container, so I use the point cloud of the empty container and the filled one.)

Thanks
Lena

Pages: [1]