Messages

1

General / Add Photos

« on: March 25, 2019, 12:38:42 PM »

Hi,
currently I am having the problem that added Photos wont align, neither in a new chunk nor in the existing one. Im always getting "exit code 1"
I have no Idea if there is another way to add photos to an existing project?
Maybe somebody had the same problem and found a solution....

Thanks in advance!

2

General / Re: Index Overflow mesh generation via depthmaps

« on: March 21, 2019, 07:24:12 PM »

Thank you I will try that!

Best regards

3

General / Re: Index Overflow mesh generation via depthmaps

« on: March 21, 2019, 03:07:22 PM »

I just send the complete log via mail

Thanks for your time
Alexey!

4

General / Re: Index Overflow mesh generation via depthmaps

« on: March 21, 2019, 02:19:56 PM »

Hi,
i am using the standard version 1.5.1 metashape
the setting was on very high with 30.000.000 Polys. There are 486 aligned cameras with 1.691.547 tiepoints.
i attached the log file, but i had to delet part of it to resize the file due to the upload requirement

Thanks for the support!

5

General / Index Overflow mesh generation via depthmaps

« on: March 21, 2019, 01:11:03 PM »

Hi All,
i am wondering if the error "index overflow" is because of Hardware limitations? I tried to generate mesh from the sparse cloud via depthmaps, and just before it was finish it crashed with exit code 0 and "Error: Index overflow"
Any suggestions or tipps to get the job done?

Thanks in advance!

6

General / Re: Estimating best cut

« on: March 06, 2019, 04:15:35 PM »

Thank you for the quick reply,
yes ive been using 1.4 and updated now for a retry.

7

General / Estimating best cut

« on: March 06, 2019, 12:31:34 PM »

Hello,
i'm currently running a big chunk (1300 jpgs) in experimental mesh generation. Since 35 hours the process is "estimating best cut". I am wondering if its stuck and i need to cancel the meshing process or if its just taking a long time? Any thoughts?