Messages

1

General / How to select disable cameras.

« on: April 30, 2019, 03:58:03 AM »

Hello, there:

How can I select all disable cameras and remove them?
I think there should be some field like status(enable/disable/flagged/etc.) but I can't find.

2

General / Re: What is depth map?

« on: April 30, 2019, 03:47:24 AM »

Oh, understood. Thank you. :-)

3

General / What is depth map?

« on: April 25, 2019, 04:11:55 AM »

I understand that using the depth map as the source would be resolved the error
that occured when I create a model using the huge number of dense cloud points.
But I do not know what the depth map is exactly.
I am curious about the concept and wonder if it can be seen in metashape.

4

General / Re: issue about support - blog - mission planning on ubuntu

« on: April 25, 2019, 03:56:50 AM »

Hello, Thank you for your prompt reply.
I want to do optimize coverage for reducing over-layered photos.
But, the menu is gone ;(

5

General / issue about support - blog - mission planning on ubuntu

« on: April 24, 2019, 12:15:05 PM »

I am using Ubuntu, and I am following the  mission planning in 'support-blog' session.
But, I found that variables of the control window are different.
And when the work is completed, there is no change in my project.
Now, what should I do to get same results of the blog? Please reply, Thx.

6

General / Re: How to remove/disable photos before dense cloud?

« on: March 15, 2019, 03:44:03 AM »

Free upgrade version? Oh, I thought it was a separate software another. I'll try. Thank you.
For now, I'm using the version 1.4.4 or 1.4.5 now

7

General / Re: How to remove/disable photos before dense cloud?

« on: March 13, 2019, 10:16:25 AM »

Thank for your prompt reply

Unfortunately, the software I am using is not metashape, but photoscan yet.
Could you tell me how to do this in photoscan?

8

General / How to remove/disable photos before dense cloud?

« on: March 13, 2019, 09:53:16 AM »

Hello community,

I read the post: https://www.agisoft.com/forum/index.php?topic=5328.0
and I'm still solving this problem.

According to the Post, he said he had disabled photos in the Model view before entering the Dense cloud process.
He said that he reduced the 3500 to 350, but I don't know how.

It seems that there must be a tool to check the overlap of pictures and a selection tool accordingly.
And I do not think I should select manually one by one, but I wonder how to do it.

Any advice is appreciated! I wait for your help.