Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - klill

Pages: [1]
1
General / Re: What does "Disable camera" actually do?
« on: February 18, 2020, 11:19:42 AM »
Thank you!
So then to remove photos that are aligned wrongly, have a large pixel error or few projections, is it correct to use "Reset camera alignment" or use the selection tools to remove points in the cloud?

2
General / What does "Disable camera" actually do?
« on: February 14, 2020, 05:28:09 PM »
Hi,
I'm quite new to the program. I am working on an aligned point cloud in Metashape, that contains a rock wall, ice and some vegetation. I am struggling to get a good point cloud, and I am working on refining it.

To my question: I am struggling to understand what the "Disable camera" function actually do. Does it just eliminate the entire photo in the processing? What is the difference between just deleting a photo, and disabling it? And how can a photo be disabled, but still aligned? 

Pages: [1]