Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Topo

Pages: [1]
1
General / Invalid license problem
« on: October 20, 2023, 04:55:02 PM »
Hi all,
i upgraded today from version 2.0.0 to 2.0.3, and metashape requires activation; I didn't noted the license number, so I tried pointing to the .lic file, getting a "no valid license" message.
The license was purchased in 2020. How do I proceed?
Thank you

2
General / Re: Question on point cloud digitalization
« on: February 18, 2021, 12:08:06 AM »
Yes, i mean in the Model view with dense cloud; i know i can attach markers and adjust vertex location, but sometime it's simpler to "snap" the vertex directly on to the nearest point of the dense cloud.
Furthermore, when i draw a shape in the model view, how is calculated the position of every vertex?

Thanks!

3
General / Re: Question on point cloud digitalization
« on: February 17, 2021, 08:36:43 PM »
Bump?

4
Feature Requests / Re: Selection Toolset -> Add Polygon Tool
« on: August 21, 2020, 07:18:30 PM »
+1

5
Feature Requests / Re: Selection mode vs Navigation mode ; Change cursor
« on: August 21, 2020, 07:18:00 PM »
Agree, can be a good quality of life improvement.

6
General / Question on point cloud digitalization
« on: February 21, 2020, 01:50:57 PM »
Hi all, sorry for a probably dumb question and a surely terrible english...
Evaluating Metashape, i've learned how can be simpler and efficient to digitalize breacklines or other fatures from DTM or Mesh compared to digitalize directly from the points cloud; however in some cases can be preferable to extract some features directly from points cloud. In these cases, why the line doesn't snap to the points cloud? And how is the height of each vertex of the line calculated?

Thanks

Pages: [1]