1
General / Re: problem with generating dense cloud and mesh
« on: September 01, 2020, 05:24:53 PM »
below is an example of such partially processed data with image overlap from the report
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General / problem with generating dense cloud and mesh
« on: September 01, 2020, 10:55:51 AM »
Hello,
While running the batch process (Build Dense Cloud, Build Mesh, Build DEM, Build Orthomosaic) no error is appearing and it shows that all the processes were excuted.
However, when looking at the results (attached below), it seems that it was not fully processed and there are gaps.
I have tried different combinations of accuracy and quality settings, still the same problem. In the past, there were some errors related to bad allocation and exceeding memory, but this time it is not showing any problems.
Please let me know what could be the reason for such partial processing. I would appreciate any suggestions.
Kind regards
While running the batch process (Build Dense Cloud, Build Mesh, Build DEM, Build Orthomosaic) no error is appearing and it shows that all the processes were excuted.
However, when looking at the results (attached below), it seems that it was not fully processed and there are gaps.
I have tried different combinations of accuracy and quality settings, still the same problem. In the past, there were some errors related to bad allocation and exceeding memory, but this time it is not showing any problems.
Please let me know what could be the reason for such partial processing. I would appreciate any suggestions.
Kind regards
Pages: [1]
