Messages

1

Bug Reports / How to keep camera position and rebuild Tie points?

« on: November 23, 2022, 11:53:24 AM »

Hi,

I'm trying to align interior picture with a lot of reflections in the area.

Most of cameras are aligning fine but few of them fly out wild.

I'd like to manually disable those cameras and rebuild the tie point but without resetting camera position.

If I reset the whole thing, because there's few photos disabled, some more camera runs off. Not ideal.

Is there a way of doing this?

Thanks!


ps. I tried to delete tie points and run "align photos" without "Reset current alignment". It doesn't make any tie point after running for few hours :/

2

General / Re: Depth map importing says "not a depth image"

« on: September 26, 2022, 01:01:07 PM »

Hi,
Sorry for late reply.

It's RGB 8bit/channel JPEG format. I tried converting it to tiff with no success.
Does it need to be Greyscale one channel?

3

General / Depth map importing says "not a depth image"

« on: September 16, 2022, 11:13:18 AM »

Hi,
I'm having a problem importing RGB image and depth map separately.
I followed the instruction here:
https://agisoft.freshdesk.com/support/solutions/articles/31000162212-smart-cameras-with-depth-sensor-data-processing
And when I feed these two jpg below, it says "RuntimeError: Not a depth image"
What am I doing wrong?