Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mfranquelo

Pages: 1 ... 10 11 [12]
166
Face and Body Scanning / First Face Scan, need tips
« on: September 16, 2013, 01:15:00 PM »
Hello  :)


I'd be really gratefull if anyone could answer these questions:
Taking account that im using one camera for tests purposes, and different views :

- Does it matter if the subject moves slightly from the first photo, till the last photo ? (this is important)

- Can photoscan take advantage of a pre-set photo-order ? for aligning purposes, more or like the ptgui templates or position xml's.
- How many photo's are needed to reduce the noise till its merely noticeable ? using a canon 600d 100 iso 50mm lens
- I?ve read that you need atleast 3 cameras pointing 45 degrees - 90 degrees for accurate point depth calculation, anyone had any experience with the minimum number of cameras needed to scan a face with quite reasonable accuracy and noise ratio ?

Thanks in advance.

Manuel.

167
General / Re: Artifacts / Noise on 3d Model
« on: September 11, 2013, 12:15:14 PM »
Thank you a lot, i sent a response  :)

168
General / Re: Artifacts / Noise on 3d Model
« on: September 10, 2013, 04:26:48 PM »
7eicher > Yes, the next step is to try this to see the results :)
Wishgranter> Thank you, that would be great. Ill contact you!

I dont want to go offtopic but my possibilities or tests relay on what i want to achieve:

Im trying to obtain a fairly good 3d model of a face (probably until the ears + chin) for surgery purposes.
The system needs to be "cheap". So i need to find a good mix between budget, quality and time.


- I thought that maybe 6, Canon600d would be sufficient to achieve this (maybe more cameras but cheaper ones ?)  (Any ideas?)
- Before this, im trying to get familiar with pasive stereophotogrammetry. (This is why i did this short test with "36" cameras)

Again, thank you for your kind support. :)


169
General / Re: Artifacts / Noise on 3d Model
« on: September 10, 2013, 02:53:12 PM »
Here are the results:
- Noise is still there, however its smoothed out leading to loose of detail or innacurate forms

- I notice that noise is present in shadow zones, or cavities of the sculpture facsimil. (but theyre seen zones by the cameras) so it shouldnt be a problem of overlap shouldnt it ?

- A colleague of me processed this same object with a different set up he did, i remember seeing less noise, maybe i did something wrong ?

Thank you!

170
General / Re: Artifacts / Noise on 3d Model
« on: September 10, 2013, 01:42:17 PM »
Thank you for the kind support  :)

> Wishgranter - I already used Arbitrary mode on mesh generation, sorry for not pointing that out.
> Alexey - I?ll try that, thank you!

171
General / Artifacts / Noise on 3d Model
« on: September 10, 2013, 10:59:59 AM »
Hello,

Im getting some strange noise / artifacts on my 3d model, i dont know what may be the source of this.
-> i shot this white matte object using diffuse / constant lighting
-> Canon MarkII 50mm lens
-> Fixed camera position, rotating the object on a tripod. 36 photos.
-> (I used mask from background)

Settings: Mild
Quality: High
Geometry type: Sharp
No decimation

Any ideas ?

Thank you,
Manuel.

Pages: 1 ... 10 11 [12]