106
General / Re: Zbrush - Workflow
« on: December 20, 2013, 09:44:50 PM »
1- smoking kills.
2- perhaps, you may add more cameras ?
I don't think editing should take more than 20min for 3d print.. Am I wrong? it seems something is wrong. Cos with Zbrush you are giving so much detail. Okay it will look good on your pc. However the printer can't print this details especially for small models.
2- perhaps, you may add more cameras ?
I don't think editing should take more than 20min for 3d print.. Am I wrong? it seems something is wrong. Cos with Zbrush you are giving so much detail. Okay it will look good on your pc. However the printer can't print this details especially for small models.