Messages

16

Feature Requests / Mesh boundaries

« on: February 21, 2014, 02:20:09 PM »

Hello,

For some projects it's not possible to use the bounding box for project limits (corridor, curve...).

It would be great to draw the boundaries of the mesh using a tool like the intelligent scissors (used for masks).

Currently, mesh boundaries follows segments of the mesh pieces. Consequently, the orthofoto limits are not straight (see attachments).

17

General / Re: Seamlines in 1.0.1-1812

« on: February 13, 2014, 05:11:49 PM »

Thanks for your reply.

The orthophoto is generated from the DSM and not from the DEM.
I know that consequently, the buildings can not connect perfectly. As against, with a slight blur or transparency, seamlines would be more discreet as in the previous version of PhotoScan.

Maxime

18

General / Seamlines in 1.0.1-1812

« on: February 13, 2014, 01:55:07 PM »

Hi,
In the previous version of PhotoScan, Seamlines were blurred which made them almost invisible. In the new version, the cuts are sharp which makes them visible.
Moreover, seamlines are sometimes twisted without any reason. (see examples)

Work parameters :
Dense cloud : medium
Classified ground points (auto)
Mesh on ground dense cloud (medium)
Decimate mesh
Ortho : mosaique

Is there a parameter that has escape me?

As seen in other posts, it could be great to manually choose the Seamlines. Or otherwise avoid passing on elevation objects when the points of the dense cloud are classified.

Thanks.

19

General / Re: Help with new tool classify points

« on: February 12, 2014, 03:33:27 PM »

Simply !
Thanks a lot 

20

General / Re: Help with new tool classify points

« on: February 12, 2014, 03:07:41 PM »

It explains how you can re-run classification with another settings if the result is not acceptable. Note that you need to reset the classification, since points already marked by Ground class would not change their class.

Hi,

I don't find the procedure to reset the classification...
Somebody can help me ?
Thanks

21

Bug Reports / Re: Unable to open a project just save with 1.0.1

« on: February 11, 2014, 03:43:22 PM »

Thanks a lot for your answer, it works very well!

We were testing photos coming from a new camera, and another computer...

Origin "Imagerie Num?rique ACD system" is now deleted from all the exif photos. and next time we will look at it first!

Thanks again, have a good day.

22

Bug Reports / Resolved - Unable to open a project just save with 1.0.1

« on: February 11, 2014, 02:47:34 PM »

Hi all.
We have a nearly same problem that HenriPierre.

We have the 1.0.1 build 1812 (64-bit) - Windows 7 familial premium, 8GB and an i7 870 @2.93Ghz.

All was ok until today, but this morning when we save a project, then close it, and then try to re-open it, we have an error : "Can't open file".

Older projects made with version 0.9 can be open, saved and re-open.
Even a project made last week with 1.0.1 can be open and save as and re-open without any problem.

So the problem is just for the new project of this morning.

We tried to uninstall and re-install photoscan without success.

We tried a small project with only 2 photos, and it is the same problem, we can't re-open it after saving and close.

There is an attachment of a little project for example.

Thanks for helping.