Show Posts
16
General / Block Edge Snap issues
« on: May 13, 2014, 06:02:13 AM »
I used 784 images created a project, because the area is relatively large, so I write a Python script to output data blocks, then each chunk separately build density point clouds, build models and textures.
But the generated model in place there is always a thin gap of the side, as shown in the following picture (2.jpg),I think it's a edge snap question. can you tell me how to handle it?
But the generated model in place there is always a thin gap of the side, as shown in the following picture (2.jpg),I think it's a edge snap question. can you tell me how to handle it?
