Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Joo

Pages: [1]
Face and Body Scanning / Multicolor 3D prints
« on: July 09, 2016, 09:34:19 PM »
I have a question for those who ordered many prints. How much better do monocolor adujsted textures prints than rather photorealistic? I have seen many great photorealistic models that printed very poorly.

I am working currently on the model that I would like to print. Could you advise me with it. First version is the better looking texture but I sense it would not print well, on the second I am qualizing the colors to the maximum. It does not look good in a digital view but do you think it will give the better results while I 3D print it? If so, is there really need to go this far with equalizing colors to get a perfect print?

Face and Body Scanning / Issue with cameras import
« on: November 04, 2015, 03:06:13 PM »
I am having a problem that never happend in Photoscan to me before. I am generating a model from two photo sets with and without projection. Once I build mesh from set with projection and export cameras I am unable to import them to the set without projection to apply texture.
The only thing that imports is a region box, no cameras visible although aligning process (after import) goes normally. Cameras calibration for both sets are the same.

Does any of you know what might be the reason of that?

Face and Body Scanning / Re: Planning to open 3D scan studio
« on: May 27, 2015, 01:18:33 AM »
Thanks a lot for you replies! You've been very helpful. I will have to do more research on this subject before I will get into this.

Face and Body Scanning / Planning to open 3D scan studio
« on: May 24, 2015, 08:04:11 PM »
I am thinking to open 3D scanning store in a mall in to sell people their figurines after taking a scan. The plan is to order 3D prints from Sculpteo or Shapeways (do you have any experience with them?). I've worked as a freelancer with cleaning 3D scans and I really liked that business idea. I generated models from 100 pi cameras setup (photos without and with projection) in Photoscan later edited models in ZBrush and Photoshop, simple job. What is your opinion on cameras? How much should there be to take full body scan in a very good quality? Is there a lot of difference between pi cameras and DSLR cameras? Is it much of a problem to setup all cameras and would it be possible to do it in a mall or are there some special requirements? When you were setting up your studio did you buy each cameras and did all the job yourself or did you buy it all prepared and ready (I saw some companies that offered such setup)?

I am at the moment collecting data about this idea, so I will be very thankful if you could answer some of my questions! :)

Pages: [1]