Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Airgo

Pages: 1 2 [3]
31
General / Re: Agisoft PhotoScan 1.2.0 pre-release
« on: September 08, 2015, 04:53:15 PM »
Hello Alexey,
seems that I did not recalculate the DEM, just the contours.
If I recalculate both of them coordinates are right.
Sorry for inconvenience,
Mathias

32
General / Re: Agisoft PhotoScan 1.2.0 pre-release
« on: September 08, 2015, 02:24:15 PM »
Hello,
if I convert the initial coordinate system (WGS84) to DHDN,Gauss-Krüger, Zone4 and export calculated contours to shape files the projection of the shape file is still the initial coordinate system (WGS84).
Best regards,
Mathias

33
General / Re: Agisoft PhotoScan 1.2.0 pre-release
« on: September 03, 2015, 08:00:50 PM »
Hello Alexej,
what are the shapes supposed for?
I expected them (especially the polylines) for drawing breaklines in the orthofoto. The polyline knows its 3D-Data (in the measure-dialog) but they export as 2D-Polylines in the shape-file.
The contours as well export only 2D.
It would be nice to export them as 3D-Polylines in dxf.
Best regards,
Mathias

34
General / Re: Agisoft PhotoScan 1.2.0 pre-release
« on: September 02, 2015, 03:23:44 PM »
Hello Mathias,

Have you used Assign image option? As there are small areas with black borders inside the shape that look like the automatically created seamlines.

Hello Alexey,
yes I used the Assign image option. The small areas with black borders appeared after the Update Orthomosaic command.

Mathias

35
General / Re: Agisoft PhotoScan 1.2.0 pre-release
« on: August 27, 2015, 02:13:17 PM »
Hello mwillis,

The procedure can be briefly described as follows:
- after building the orthomosaics open it in the Ortho tab by double-clicking on the corresponding line in the Workspace pane,
- choose Draw Polygon instrument on the toolbar,
- draw a polygon,
- select polygon with the left-click then right-click on it and choose Assign Images in the context menu,
- specify the image (or images) to be used for the current fragment,
- repeat previous steps any times you wish on different areas,
- when all the changes have been made press Update Orthomosaic button on the toolbar to apply the changes (it will take some time).
Hello Alexey,
I tried this workflow hoping that roofs will be computed with higher accuracy.
So I marked a roof with the polygon and assigned an image to it where the whole roof is visible.
But the jagged roof edge is still there.
I have attached a screenshot.

Regards,
Mathias

Pages: 1 2 [3]