Messages

1

Bug Reports / Re: Mesh imperfections

« on: September 12, 2016, 02:27:31 AM »

Apologies for the long delay, I've been out of office since the original post.

I was using the latest version available for download, and the minor version before that to build the meshes in the original project. I updated with the hope that it would address these mesh issues but it didn't help.

I will look at the diagnostics dialogue tomorrow to see if anything appears. I also tried building with and without OpenCL enabled but that didn't help either.

2

Bug Reports / Mesh imperfections

« on: September 02, 2016, 04:26:34 PM »

Hi there,

I've been doing some work in Photoscan recently and started noticing 'imperfections' in the form of a number of overlapping faces on the meshes. I've attached an image showing what I mean. I'm using a typical workflow so I doubt it's anything I've introduced. Meshes generated will often have tens, possibly hundreds of these overlapping, dodgy tri's.

The problem is that it then causes issues when viewed in shaded mode, and later in rendering too. This means I have to export into another package and retop or fix the offending parts of the mesh, reimport into Photoscan and recalculate textures.

I've not experienced or noticed this before so I assume it's a bug, though I'd like if someone could clarify/corroborate this?

Cheers

3

Bug Reports / Hangs/freezes when Building Texture with 2 or more maps

« on: September 25, 2015, 06:46:42 PM »

Hi,

First post and it's about an issue I'm having with building the texture on a mesh. Build Texture runs absolutely fine when generating 1 map (e.g. 8096 x 1) but as soon as I switch the settings up to generate lower resolution over more maps (e.g. 2048 x 4 or 4096 x 2) it freezes having processed for a while (usually around the end of Parameterizing Texture Atlas or Blending Texture at 85% depending on whether blending is Generic/Off).

Machine is decent spec (2 x Xeon E5-2650, 128GB RAM) and has no issue generating large single maps (i.e. 16k+) so I don't think RAM is an issue. Has anyone experienced a similar issue? Thoughts very much appreciated, cheers