Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Chernabog

Pages: [1]
Bug Reports / Re: launch error at line 67
« on: March 21, 2017, 05:23:15 PM »
I concur with bortoman, build 3943 seems to have fixed the "line 67" error message I was getting on dense point cloud generation.

I have more work to process so if anything else weird turns up I will report it here.



Bug Reports / Re: launch error at line 67
« on: March 01, 2017, 02:12:51 PM »
Hi All,

Just to say that I too am experiencing this same issue trying to stich about 200 36 MP images using the Photoscan version 1.3.0.

Our system spec is as below:
18 virtual processor Xeon E5-2660 v3 (2.6 Ghz)
112 GB RAM
Nvidia GRID K2 (8 cores @ 745 Mhz, 4096 MB vRAM)

Works fine using CPU only, just takes an age to complete.



General / Re: Change Photoscan default opening view?
« on: March 17, 2016, 02:16:14 PM »

Thats exactly what I was looking for, works a treat.

Many thanks,


General / Change Photoscan default opening view?
« on: March 16, 2016, 03:03:23 PM »
Hi All,

I have become stuck with one of my projects that I have been working on using ULTRA settings for the most part, because I foolishly created a mesh, texture etc. for it (far too many polygon faces!) which causes Photoscan to crash if the mesh or textured mesh is viewed.

This means that I curently cannot re-open the project as the first thing it tries to dispaly is the textured mesh (so it crashes) and I have also tried apending the project into a new project (same result).

Is there any way to be able to either delete the mesh (I have tried just renamaing the model zip file but that didn't work), or make it so that photoscan does not try to show the mesh as default when a project is opened?

Thanks in advance,


Pages: [1]