31
Bug Reports / Re: Compact dense cloud problem
« on: March 07, 2017, 01:47:37 AM »
THANK YOU VERY MUCH !
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
32
Bug Reports / Re: Compact dense cloud problem
« on: March 05, 2017, 07:44:20 PM »
Hi Alexey,
I was just editing, no classification. I use the basic module of photoscan 1.3.
I open the project again and I noticed that when I move the arrow cursor on the model window on the console pane appear the message ERROR : null file repeatedly during cursor movement. When the cursor is outside the model window the printing error: number is stopped.
In the mean time I reproduced the dense point cloud with the same sparse point cloud and everything is ok.
I attach the console pane output.
Thank you for your answer.
I was just editing, no classification. I use the basic module of photoscan 1.3.
I open the project again and I noticed that when I move the arrow cursor on the model window on the console pane appear the message ERROR : null file repeatedly during cursor movement. When the cursor is outside the model window the printing error: number is stopped.
In the mean time I reproduced the dense point cloud with the same sparse point cloud and everything is ok.
I attach the console pane output.
Thank you for your answer.
33
Bug Reports / Compact dense cloud problem
« on: March 04, 2017, 03:15:17 PM »
Photoscan 1.3
After editing dense point cloud (deleting unwanted points) and choosing from Tools menu -> Compact Dense Cloud,
part of dense cloud model appears as sparse cloud and part as dense. Subsequently created mesh model is ok, textured model is ok.
error : Null Image( many times)
After editing dense point cloud (deleting unwanted points) and choosing from Tools menu -> Compact Dense Cloud,
part of dense cloud model appears as sparse cloud and part as dense. Subsequently created mesh model is ok, textured model is ok.
error : Null Image( many times)
34
Feature Requests / correlated radial distortion parameters
« on: November 14, 2016, 10:22:06 PM »
It is not clear to me How to disable a radial distortion parameter K2 K3 etc from calculations, when there is a high correlation > 0.90 between k1,k2 or k3. The same holds for p1,p2 etc
