Messages

1

General / Re: Updating coordinate in reference pane

« on: October 17, 2017, 09:35:25 AM »

Thank you for the answer! so, to clarify, there is no way to fix the mistake in marker coordinate while keeping the dense cloud, correct?

2

General / Updating coordinate in reference pane

« on: October 17, 2017, 08:37:42 AM »

Hi! I currently working with approx 1500 photos and 15 GCP. I had already build dense cloud until suddenly there is an update of GCP coordinate from survey division. I was wondering if I could just update the coordinate without having to re-optimize and redo build dense cloud.
Is UPDATE button on reference pane doing the thing I require?
thanks a lot for fast response!

3

Bug Reports / Update orthomosaic failed

« on: September 10, 2017, 05:56:02 AM »

Hi, i was trying to update orthomosaic in agisoft 1.3.2 version using assign images function but it was failed to "fully" update. Can somebody explain why?

4

General / Arbitrary Mesh Build of 2500 photos

« on: April 06, 2017, 01:15:33 PM »

Hi,

I was testing to build mesh from approx. 2500 photos of village area with arbitrary setting in build mesh. Photos was build with medium dense cloud setting. High and medium face count cause the software to force close. Meanwhile low face count (about 4 million faces) takes so long to finish, > 40 hours. I closed it after 12 hours of process.

My computer uses 64 GB of RAM and dual GTX 1070. Task manager shows full usage of RAM during process (around 61 GB ram used). I knew that arbitrary mode consumes huge RAM compared to height field mode, but is it normal? If I want to build a 3D model from arbitrary mesh, what should be the best setting then (e.g low dense cloud, low face count)?

Thanks

5

Bug Reports / Re: Alignment Issue

« on: January 27, 2017, 07:58:55 AM »

Thank you for the response, I will check whether there are any issues with the RAM using memtest86. I was testing the PC using windows memory diagnostic, but it didn't show any problem with the RAM.

6

Bug Reports / Re: Alignment Issue

« on: January 26, 2017, 05:48:18 AM »

I'm afraid full processing log is gone because i didn't see the processing log at the time of the processing, perhaps because I restarted the computer. Is there any way we can get the processing log for the whole process (before the computer restarted)?

7

Bug Reports / Alignment Issue

« on: January 25, 2017, 12:44:17 PM »

I'm having a trouble with alignment process where alignment attempts failed and the message is "out of bounds node index". Is anyone ever get this message and know the source of the issue? Total attempted photos to be aligned are 2120 photos (source DJI phantom 3), with Alignment setting is High, Generic, 50000 key point limit and 0 tie point limit. I am suspecting 0 tie point limit as the source of the issue but I'm not really sure.