16
General / Re: Minimum image coverage options
« on: September 20, 2017, 03:05:53 PM »
Hi Dave,
Thanks for responding. I tried disabling each of the three overlapping images to see if it would make a difference, but it did not. I've also tried adjusting the quality of the alignment (highest to low) with no further success. Are there any additional manual alterations I can make during alignment that would prevent Agisoft from dropping those wedge points even if their error is anomalously high for one reason or another?
Thanks!
Thanks for responding. I tried disabling each of the three overlapping images to see if it would make a difference, but it did not. I've also tried adjusting the quality of the alignment (highest to low) with no further success. Are there any additional manual alterations I can make during alignment that would prevent Agisoft from dropping those wedge points even if their error is anomalously high for one reason or another?
Thanks!