Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Sparkling_Water

Pages: [1]
Python and Java API / Re: Finish half-processed Projects via API
« on: March 22, 2022, 05:54:22 PM »
That helps, it's now working!


Python and Java API / Re: Finish half-processed Projects via API
« on: March 22, 2022, 04:20:49 PM »
Thank you!

I've tried and so far it opens the project and makes it readable with a small workaround that I found in this forum

Code: [Select]
i = "***\test.psx"
path = i
doc =, read_only=True)
doc.read_only = False
doc =, read_only=False)

(I've got this from )

then, when I try to build the DEM with

Code: [Select]
buildDem(source=Metashape.PointCloudData, interpolation=Metashape.EnabledInterpolation) or
Code: [Select]
chunk.buildDem(source=Metashape.PointCloudData, interpolation=Metashape.EnabledInterpolation)
I get the errors
NameError: name 'chunk' is not defined or NameError: name 'buildDem' is not defined

so I tried to select the chunk but didn't manage without building it. But I just want the half-finished project that is already sitting in the chunk (usually there is only 1 chunk).

How can I fix this?


Python and Java API / Finish half-processed Projects via API
« on: March 19, 2022, 09:24:33 PM »
I've got a bunch of projects where we did the data import and geo-tagging manually and I would like to do the DEM and Orthomosaic via API, as it is less clicking than the batch method. I can re-open and re-save a half-finished project with the my code, but afterwards it gets stuck.
I was wondering whether this is possible, since all the codes I have reviewed in the forum start with importing the photos and forming the chunks, whereas I already have my photos aligned in one chunk. I keep getting error messages related to the chunk and the data source.

Thank you

General / Remove Calibrate Reflectance
« on: January 07, 2019, 04:03:17 PM »

I used "calibtrate reflectance" with sun sensor and the reflectance panels on my agisoft projects (camera: Micasense Red Edge M). However, I would like to export an orthomosaic with sun sensor calibrated only. Is there a possibility to remove the calibration? Do I have to start the whole project all over?

Thank you for your answers

Thank you very much for your answer. I will consider this for the next time.

But how is this section meant with saving intermediate reuslts during the process?

"Saving intermediate results
Certain stages of 3D model reconstruction can take a long time. The full chain of operations could
eventually last for 4-6 hours when building a model from hundreds of photos. It is not always possible to
complete all the operations in one run. PhotoScan allows to save intermediate results in a project file.
" - Agisoft Manual 1.4 p 35

Hi all

We were generating a point cloud out of a large number of photos (+2000) and during this process the computer crashed.
As I read in the manual page 35 ("saving intermediate results"), agisoft saves intermediate steps.

Can I restart the dense point cloud from these intermediate results instead of making an entierely new point cloud?

How can I reload these intermediate steps?

Thank you

Pages: [1]