Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - WinterGuy

Pages: [1]
Bug Reports / Windows 8 crash and burn with 32bit demo
« on: December 02, 2012, 03:17:35 AM »
I downloaded the demo earlier today(the 32bit ver) it runs fine on a windows 7 computer(minus the occasional "out of memory" issue which is to be expected. I thought that I would give my other laptop a shot which has windows 8. After running the program all works up until the mesh is almost generated in the build geometry phase then... complete and utter crash of Agisoft unless the minimal settings are being used. Now I just installed the 64bit version and everything works great but I am curious as to why it crashes. Now I know a 64bit system can run like 2x the ram but if a lack of memory was the issue why did I not get the same error message "out of memory". Any ideas?

Pages: [1]