Forum

Author Topic: Error when generating ortomosaic  (Read 2350 times)

akros_cl

  • Newbie
  • *
  • Posts: 2
    • View Profile
Error when generating ortomosaic
« on: January 10, 2019, 01:26:28 AM »
Dear Aghisoft users

I have problems in the generation of the complete final ortomoaic.

The project is a corridor mapping of approximately 20km. I´m using Aghisoft Metashape 1.5.0 build 7125.
I have already generated the point cloud and also the complete DEM and without any problem. But as you can see in the images the ortomosaic has only been generated in about 85%.

Could someone give me a hand with this problem?

Does anyone have any idea what may be happening? I have processed the same project twice and the same thing continues to happen.

Regards from Chile.

Victor

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Error when generating ortomosaic
« Reply #1 on: January 10, 2019, 02:11:18 PM »
Hello Viktor,

Can this issue be reproduced on the smaller sub-set of images from this project?

If so, then could you share the minimal project with support@agisoft.com? To reduce the project size leave only alignment results (including tie points, but key point could be removed), DEM and image thumbnails. The original images are not required at this moment, as we would generate them from the thumbnails.
Best regards,
Alexey Pasumansky,
Agisoft LLC