Hi all!
I am trying to rerun a model, previously successfully completed in Agisoft. My colleague says he only uses the 'defaults, with all the quality parameters on Ultra High or Highest' and 'follows the workflow of Align Photos>Densify>Mesh>Tile'
This worked on a relatively low spec'd PC
I ran the model on my PC, which is more powerful, but via Metashape. I run out of memory!
I have looked back at the original files and used the Info button to reconstruct the process step by step. I get to a Dense PC which has almost identical parameters (I attach a pic of the original PC info).
Then I mesh, and things go wrong. I attach a pic of the mesh set up in the original. I cannot:
Understand how so few faces come from a c. 540 million point PC
See where you set some of these parameters (e.g. Quality = Lowest)....if I accept mesh from cloud, I cannot set a quality parameter
Get such a point cloud to mesh in 2 minutes!
As a newbie to Metashape, am I doing something wrong, or missing something in the dialogue boxes?
Thanks
Paul