Forum

Author Topic: Shapes made in DEM not retroprojected to Dense Cloud & Mesh  (Read 1423 times)

GrinGEO

  • Sr. Member
  • ****
  • Posts: 262
    • View Profile
Shapes made in DEM not retroprojected to Dense Cloud & Mesh
« on: February 06, 2019, 07:03:11 PM »
To create a Shape as Outer Border I normally do it in DEM view, becouse there I can see where I have the most artefacts that need to be cut off in the outer area.
Unfortunately, when made in DEM view the shape is only visible in the Orthofoto, but not in the Dense Cloud & Mesh View.

It would be good becouse especially for OBJ export for clients I normally clean the outer boarder manually to avoid any strange artefacts.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14104
    • View Profile
Re: Shapes made in DEM not retroprojected to Dense Cloud & Mesh
« Reply #1 on: February 06, 2019, 07:21:33 PM »
Hello GrinGEO,

If every vertex of the drawn shape is put over DEM with the valid altitude values, select the shapes that you would like to see in the Model view, right-click on selection and choose Update Altitude option from the context menu. The shapes will have the altitude for each vertex applied, so you can see them in 3D view mode.
Best regards,
Alexey Pasumansky,
Agisoft LLC

GrinGEO

  • Sr. Member
  • ****
  • Posts: 262
    • View Profile
Re: Shapes made in DEM not retroprojected to Dense Cloud & Mesh
« Reply #2 on: February 06, 2019, 08:13:48 PM »
amazing help... improves my workflow again.
Thanks