Forum

Author Topic: Aligning with Point Based Method  (Read 1098 times)

eytanmannko

  • Newbie
  • *
  • Posts: 3
    • View Profile
Aligning with Point Based Method
« on: February 21, 2019, 09:40:11 PM »
Hello,

I'm trying to align multiple chunks using the align chunk command, using Point Based alignment.
I've noticed that it will align only two-chunks at a time. Not all chunks.

If I use camera based alignment, I can do multiple chunks at a time...

Anyone knows why is that?

Thanks

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Aligning with Point Based Method
« Reply #1 on: February 21, 2019, 09:47:00 PM »
Hello eytanmannko,

Which type of the project you are working with?
Best regards,
Alexey Pasumansky,
Agisoft LLC

eytanmannko

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: Aligning with Point Based Method
« Reply #2 on: February 27, 2019, 02:52:45 AM »
Hi Alexey, thanks for replying.
Trying to do an architectural building exterior... is that what you mean by type?